Search results
Results From The WOW.Com Content Network
An electromagnetic pump is a pump that moves liquid metal, molten salt, brine, or other electrically conductive liquid using electromagnetism. A magnetic field is set at right angles to the direction the liquid moves in, and a current is passed through it. This causes an electromagnetic force that moves the liquid.
Durability needs to be incorporated into pump design to the handle the heavy use (and abuse). The India Mark II is a human-powered pump designed to lift water from a depth of 50–80 m. [1] The Mark II is world's most widely used water handpump. [2] The pump was designed in the 1970s to serve village water needs in developing countries and ...
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom.
This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...
The diaphragm or bladder may itself exert a pressure on the water, but it is usually small and will be neglected in the following discussion. Case 1 is an empty tank at the charging pressure P c (gauge). The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V
Zhuzh! (www.zhuzh.com) VIDEO: Steve Whatley (wearing a blue suit and yellow and blue striped tie) during Ideal World's Launch Night (www.shoppingtelly.com) "Interview with Steve Whatley" published 8 June 2005 (www.shoppingtelly.com) VIDEO: Ken Oschipok and Ellis Ward announce the death of Steve Whatley on Ideal World (www.shoppingtelly.com)
The strength of the vacuum produced depends on the velocity and shape of the fluid jet and the shape of the constriction and mixing sections, but if a liquid is used as the working fluid, the strength of the vacuum produced is limited by the vapor pressure of the liquid (for water, 3.2 kPa or 0.46 psi or 32 mbar at 25 °C or 77 °F). If a gas ...
Water is inexpensive, non-toxic, and available over most of the earth's surface.Liquid cooling offers higher thermal conductivity than air cooling. Water has unusually high specific heat capacity among commonly available liquids at room temperature and atmospheric pressure allowing efficient heat transfer over distance with low rates of mass transfer.