Search results
Results From The WOW.Com Content Network
The V3 engine is a V engine with two cylinders in one bank and one cylinder in the other bank. It is a rare configuration, which has been mostly used in two-stroke engines for motorcycles competing in Grand Prix motorcycle racing. The first example was the 1955 DKW 350. [1]
This effect increases with the number of cylinders in the engine; the length difference between V-twin and straight-twin engines might be insignificant, however V8 engines have a significantly smaller length than straight engines. [6] Compared with the less common flat engine, a V engine is narrower, taller and has a higher center of mass.
A V-twin engine, also called a V2 engine, is a two-cylinder piston engine where the cylinders are arranged in a V configuration and share a common crankshaft. The V-twin is widely associated with motorcycles , primarily installed longitudinally, though also transversely.
A group of cars at the Snetterton Circuit, featuring three Group GT3 manufacturers. Group GT3, known technically as Cup Grand Touring Cars [1] and commonly referred to as simply GT3, is a set of regulations maintained by the Fédération Internationale de l'Automobile (FIA) for grand tourer racing cars designed for use in various auto racing series throughout the world.
The J25A was used only in the Japanese domestic Inspire/Saber models. The J25A displaced 2.5 L; 152.3 cu in (2,495 cc). Its bore and stroke was 86 mm × 71.6 mm (3.39 in × 2.82 in). The J25A used a 10.5:1 compression ratio and was a SOHC VTEC design. Output was 200 hp (149 kW) at 6200 rpm and 24.5 kg⋅m (240 N⋅m; 177 lb⋅ft) of torque at ...
The cars in this series use wings that are designed to move with the airflow over the car, lying almost level with the ground on straights and standing up in turns to increase downforce. The only engine allowed by ISMA is a cast-iron big block with a maximum displacement of 468 cu in (7.7 L).
All American Grand Touring (AAGT) [10] was maintained by IMSA between 1975 and 1989. [11] These cars were All-American, V8-powered, used a maximum of 5 forward gears, and used a steel tube frame (similar to the type used in the SCCA Trans-Am Series), and were designed to compete against heavyweight European manufacturers and machinery of the time, such as Porsche and BMW, who were dominating ...
This is a list of vehicles that have been considered to be the result of badge engineering (), cloning, platform sharing, joint ventures between different car manufacturing companies, captive imports, or simply the practice of selling the same or similar cars in different markets (or even side-by-side in the same market) under different marques or model nameplates.