Ad
related to: printable ruler measurements inches
Search results
Results From The WOW.Com Content Network
The pica is a typographic unit of measure corresponding to approximately 1 ⁄ 6 of an inch, or from 1 ⁄ 68 to 1 ⁄ 73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
It is 5.5 typographical points, or about 1 ⁄ 13 inch (1.94 mm). It can refer either to the height of a line of type or to a font that is 5.5 points. An agate font is commonly used to display statistical data or legal notices in newspapers. It is considered to be the smallest point size that can be printed on newsprint and remain legible ...
Wide ruled (or legal ruled) paper has 11 ⁄ 32 in (8.7 mm) spacing between horizontal lines, with a vertical margin drawn about 1 + 1 ⁄ 4 inches (32 mm) from the left-hand edge of the page. It is commonly used by American children in grade school, as well as by those with larger handwriting.
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
A ruler, depicting two customary units of length, the centimeter and the inch A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units , used in every country globally.
The folding carpenters' rulers used in Scandinavia are sometimes equipped with double measurements, metric and imperial on both sides, also functioning as a handy conversion table, accounting for its Scandinavian term: Tommestokk/tumstock (thumb (inch) stick), [4] a term with the same meaning that is also used in Dutch: duimstok. Metric only ...