Search results
Results From The WOW.Com Content Network
The overhand loop is a simple knot which forms a fixed loop in a rope. Made by tying an overhand knot in the bight, it can be tied anywhere along a rope (does not need any working end). The knot can be used for attaching clips, hooks, other rope, etc., but has the disadvantage that it is likely to jam tight when the rope has been pulled and the ...
Zeppelin bend forming a loop: the four stages of the method starting with a "clover leaf" or flattened overhand knot; Red line: ends of the overhand knot, Green line: ends of the underhand. Another method of remembering this knot is to visualize a "69". To tie the knot with this method, follow the steps below: Make a "6" with one line (rope) end.
The overhand knot is one of the most fundamental knots, and it forms the basis of many others, including the simple noose, overhand loop, angler's loop, reef knot, fisherman's knot, half hitch, and water knot. The overhand knot is a stopper, especially when used alone, and hence it is very secure, to the point of jamming badly. It should be ...
Water knot (also known as Tape Knot, Double Overhand Bend, Ring Bend): The Water knot is useful to tie together two ends of ropes. Often used with webbing. Binding Strangle knot: The Strangle knot is a simple binding knot. It forms both sides of a Double fisherman's knot, and is also used to back up loop knots and both ends of bends. Hitches
A slipped half hitch [1] [2] is a knot in which the weight of the load the rope carries depresses the loop sufficiently to keep it in place until the load item is placed in its location. When no longer required the free end may be pulled and draw the loop through and so release the load.
Create a loop in the rope. Then pull a bight of the working part through the loop, creating an overhand noose knot. Pull another bight of the working part through the loop of the previous stitch. Tighten the stitch to the desired degree by pulling on both sides of the loop. Adjust the loop by pulling on the working end to keep it a reasonable size.
Below is a basic method of tying. The knot can also be made by using the rod itself to form the loop, but the tying method does not affect the performance of the resulting hitch. Begin with an overhand loop, that is, a loop in which the working part passes over the standing part:
There seemed to be no better way than to start with the two halfs that make up the famous Sheet bend... an open loop and a single hitch. — Dr. Harry Asher: The Alternate Knot Book [ 5 ] Comparison of Sheet bend, Simple Simon over and Simple Simon under