Search results
Results From The WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
It relates to spindle speed via variables such as cutter diameter (for rotating cutters) or workpiece diameter (for lathe work). SFM is a combination of diameter and the velocity ( RPM ) of the material measured in feet-per-minute as the spindle of a milling machine or lathe . 1 SFM equals 0.00508 surface meter per second (meter per second, or ...
Typical values for cutting speed are 10m/min to 60m/min for some steels, and 100m/min and 600m/min for aluminum. This should not be confused with the feed rate. This value is also known as "tangential velocity." Spindle speed (S) This is the rotation speed of the tool, and is measured in revolutions per minute (rpm).
The speed at which the piece advances through the cutter is called feed rate, or just feed; it is most often measured as distance per time (inches per minute [in/min or ipm] or millimeters per minute [mm/min]), although distance per revolution or per cutter tooth are also sometimes used. There are two major classes of milling process:
To achieve optimal surface speed and cutting conditions, burrs are rapidly rotated at high speeds, often in the range of thousands or tens of thousands of RPM, which is typically the maximum speed supported by a given spindle. The cutters depicted in the image, being made of tungsten carbide, can withstand and operate at these elevated speeds.
A self-releasing die head can rapidly cut or roll-form threads on outside diameters. A non-releasing tap holder with a tap can quickly cut inside diameters but it requires single spindle machines to reverse into high speed in order for the tap to be removed from the work. Threading and tapping speed (low speed) is typically 1/5 the high speed.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
This is somewhat normal for tool wear, and does not seriously degrade the use of a tool until it becomes serious enough to cause a cutting edge failure. Can be caused by spindle speed that is too low or a feed rate that is too high. In orthogonal cutting this typically occurs where the tool temperature is highest. Crater wear occurs ...