Search results
Results From The WOW.Com Content Network
Apollo Command Module primary guidance system components Apollo Lunar Module primary guidance system components Apollo Inertial Measurement Unit. The Apollo primary guidance, navigation, and control system (PGNCS, pronounced pings) was a self-contained inertial guidance system that allowed Apollo spacecraft to carry out their missions when communications with Earth were interrupted, either as ...
The Apollo Lunar Module (LM / ˈ l ɛ m /), originally designated the Lunar Excursion Module (LEM), was the lunar lander spacecraft that was flown between lunar orbit and the Moon's surface during the United States' Apollo program. It was the first crewed spacecraft to operate exclusively in the airless vacuum of space, and remains the only ...
Kelly was promoted to lead the design team for the Lunar Excursion Module (LEM). He was in charge of more than 7,000 employees in design and building the Lunar Module. Kelly's group came up with the idea of a two-stage spacecraft (ascent & descent stage), that would take two astronauts to the Moon's surface while a third astronaut would stay in ...
The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...
The ascent propulsion system (APS) or lunar module ascent engine (LMAE) is a fixed-thrust hypergolic rocket engine developed by Bell Aerosystems for use in the Apollo Lunar Module ascent stage. It used Aerozine 50 fuel, and N
In 2010, the legacy brands of Premier Electronics, Farnell and Farnell-Newark were replaced by Farnell element14 in Europe, and by Newark element14 in the US. The name was taken from silicon, the 14th element in the Periodic Table, which is widely used in electronic components such as integrated circuits and discrete semiconductors. [18]
Actuator Sensor Interface (AS-Interface or ASi) is an industrial networking solution (Physical Layer, Data access Method and Protocol) used in PLC, DCS and PC-based automation systems. It is designed for connecting simple field I/O devices (e.g. binary ON/OFF devices such as actuators, sensors, rotary encoders, analog inputs and outputs, push ...
They utilize a "current-sense resistor" to convert the load current in the power rail to a small voltage, which is then amplified by the current-sense amplifiers. The currents in the power rail can be in the range of 1 A to 20 A, requiring the current-sense resistor to be a resistor typically in the range of 1 to 100 mΩ.