Search results
Results From The WOW.Com Content Network
A dog clutch, however, is a binary system, thus requiring that the rotating speeds of the two discs be matched prior to mating to avoid damage by jerk within the system - this can be achieved automatically, such as by implementing a synchromesh mechanism, or manually, as in a crash gearbox.
Dog clutch used to drive the rotating platter in a microwave oven. Dog clutch (disengaged) on the countershaft gears of the Honda CBR600RR transmission.. A dog clutch (also known as a dog box, dog gears, dog ring, clutch dog, or positive clutch) is a type of clutch that couples two rotating shafts or other rotating components by engagement of interlocking teeth or dogs rather than by friction.
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
A cone clutch is similar to dry friction plate clutch, except the friction material is applied to the outside of a conical shaped object. This conical shape allows wedging action to occur during engagement. A common application for cone clutches is the synchronizer ring in a manual transmission.
When a back torque comes from the transmission, the splined hub slides up the bearing ramps, disconnecting from the clutch plates and allowing a limited slip between input and output. This type of clutch is designed to partially disengage or "slip" when the rear wheel tries to drive the engine faster than it would run under its own power.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.