Search results
Results From The WOW.Com Content Network
Multi-jackbolt tensioners (MJTs), registered under the trademark Superbolt or Supernut, are designed to decrease the torque required to tighten large bolted joints. One of the major problems associated with traditional bolt tightening methods is as the diameter of the bolt increases, the amount of torque required to tighten it increases in the third power of the diameter. [1]
The curve representing a clamped parts-to-bolt stiffness ratio of 0.01 shows that when the relative stiffness of the clamped parts is very low, almost all of the load is transferred to the bolt, down to the point where a compressive load equals the preload, and separation at the bolt head occurs, reducing the force in the bolt to zero.
= design axial force; and = capacity factor, which is 0.9 for tension members. There are similar formulas in the AISC and CEN codes. [1] [2] A structural analysis or finite element analysis is conducted to determine the design axial force the tension members of a structure. These calculations are performed for a series of load combinations ...
The force and torque vectors that arise in applying Newton's laws to a rigid body can be assembled into a screw called a wrench. A force has a point of application and a line of action, therefore it defines the Plücker coordinates of a line in space and has zero pitch. A torque, on the other hand, is a pure moment that is not bound to a line ...
The actual thread heights on both the internal (nut) and external (bolt) threads differ from P / 2 by allowances (or clearances): A minimum root-crest clearance of 0.01 in (0.25 mm) (diametral) between opposing threads with 10 tpi (threads-per-inch) or fewer, and 0.005 in (0.13 mm) for finer pitches.
In mechanical engineering, a helix angle is the angle between any helix and an axial line on its right, circular cylinder or cone. [1] Common applications are screws, helical gears, and worm gears. The helix angle references the axis of the cylinder, distinguishing it from the lead angle, which references a line perpendicular to the axis.
A cast-in-place anchor bolt. The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
Strength depends upon material properties. The strength of a material depends on its capacity to withstand axial stress, shear stress, bending, and torsion.The strength of a material is measured in force per unit area (newtons per square millimetre or N/mm², or the equivalent megapascals or MPa in the SI system and often pounds per square inch psi in the United States Customary Units system).