Ads
related to: double flare brake line diagram 2004 silverado truck
Search results
Results From The WOW.Com Content Network
The first generation of the Chevrolet Silverado is a series of trucks manufactured by General Motors from 1998 until 2007 under the Chevrolet brand and also as the GMC Sierra. Built on the new GMT800 platform, the Silverado/Sierra 1500 and 2500 pickup trucks were first released in August 1998 as 1999 models.
While factory-produced as a C-series truck, the front fenders were fitted with the plastic fender flares typically fitted to K2500 trucks to accommodate a wider front axle and larger (19.5-inch) tires. The model line was offered in 135.5-, 159.5-, and 183.5-inch wheelbases, the latter being exclusive to the C3500HD.
First-generation Chevrolet Silverado 2500HD (2001–02 Regular Cab) The GMT800 Silverado/Sierra 1500 and 2500 pickup trucks were released in August 1998 as 1999 models. The "classic" light-duty GMT400 C/K trucks continued to be produced for the first two years alongside the new models, and the Heavy-Duty GMT400 pickups (alongside the GMT400 SUVs) were continued until 2000, with the new GMT800 ...
An S-cam is part of a braking system used in heavy vehicles such as trucks and wheeled machinery. It consists of a shaft, usually around 4 to 25 inches long, turned at one end by means of an air-powered brake booster and lever with an S-shaped cam at the wheel end. Turning the shaft pushes the brake shoes against the drum, producing friction.
Drum brake (upper right) with the drum removed (lower left, inside facing up), on the front of a Ford Falcon Sprint A rear drum brake on a Kawasaki W800 motorcycle. A drum brake is a brake that uses friction caused by a set of shoes or pads that press outward against a rotating bowl-shaped part called a brake drum.
Truck air-actuated disc brake. An air brake or, more formally, a compressed-air-brake system, is a type of friction brake for vehicles in which compressed air pressing on a piston is used to both release the parking/emergency brakes in order to move the vehicle, and also to apply pressure to the brake pads or brake shoes to slow and stop the vehicle.
The most common flare fitting standards in use today are the 45° SAE flare [2] [3],the 37° JIC flare, and the 37° AN flare. For high pressure, flare joints are made by doubling the tube wall material over itself before the bell end is formed. The double flare avoids stretching the cut end where a single flare may crack.
Work Completed: Rear brake shoes replaced and rear brake drum skimmed, rubber gear linkage grommets replaced, flares on front wheel arches and rusty lower part of the near side wheel arch cut out and replaced with new panels, whole car sanded to bare metal and resprayed from yellow to factory Japan Red and Feather White colour combination ...