Ad
related to: electroplating chemistry ppt free
Search results
Results From The WOW.Com Content Network
Brush electroplating has several advantages over tank plating, including portability, the ability to plate items that for some reason cannot be tank plated (one application was the plating of portions of very large decorative support columns in a building restoration), low or no masking requirements, and comparatively low plating solution ...
Their main use is for high-speed plating where high current densities are required. Drawbacks to the fluoroborate chemistry include lower throwing power than acid sulfate baths, higher cost to operate, and greater safety hazards and waste treatment concerns. [2] Acid fluoroborate baths contain cupric tetrafluoroborate and fluoroboric acid.
Plating is a finishing process in which a metal is deposited on a surface. Plating has been done for hundreds of years; it is also critical for modern technology. Plating is used to decorate objects, for corrosion inhibition, to improve solderability, to harden, to improve wearability, to reduce friction, to improve paint adhesion, to alter conductivity, to improve IR reflectivity, for ...
Electroless deposition is an important process in the electronic industry for metallization of substrates. Other metallization of substrates also include physical vapor deposition (PVD), chemical vapor deposition (CVD), and electroplating which produce thin metal films but require high temperature, vacuum, and a power source respectively. [20]
Nickel electroplating is a process of depositing nickel onto a metal part. Parts to be plated must be clean and free of dirt, corrosion, and defects before plating can begin. [ 3 ] To clean and protect the part during the plating process, a combination of heat treating , cleaning, masking, pickling , and etching may be used. [ 1 ]
Trivalent chromium plating is an alternative to hexavalent chromium in certain applications and thicknesses (e.g. decorative plating). [2] A trivalent chromium plating process is similar to the hexavalent chromium plating process, except for the bath chemistry and anode composition.
Electroless nickel plating also can produce coatings that are free of built-in mechanical stress, or even have compressive stress. [16] A disadvantage is the higher cost of the chemicals, which are consumed in proportion to the mass of nickel deposited; whereas in electroplating the nickel ions are replenished by the metallic nickel anode.
Electroplating of zinc was invented in 1800, but the first bright deposits were not obtained until the early 1930s with the alkaline cyanide electrolyte. Much later, in 1966, the use of acid chloride baths improved the brightness even further. The latest modern development occurred in the 1980s, with the new generation of alkaline, cyanide-free ...