When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Centrifugal pump selection and characteristics - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump_selection...

   Pump curves are quite useful in the pump selection, testing, operation and maintenance. Pump performance curve is a graph of differential head against the operating flow rate. They specify performance and efficiency characteristics. Performance tests are done on the pumps to verify the claims made by the pump maker.

3. Pumpjack - Wikipedia

   en.wikipedia.org/wiki/Pumpjack

   Depending on the size of the pump, it generally produces 5 to 40 litres (1 to 9 imp gal; 1.5 to 10.5 US gal) of liquid at each stroke. Often this is an emulsion of crude oil and water. Pump size is also determined by the depth and weight of the oil to remove, with deeper extraction requiring more power to move the increased weight of the ...

4. Comparison of pumps - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_pumps

   Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

5. Fixture unit - Wikipedia

   en.wikipedia.org/wiki/Fixture_unit

   A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

6. Hand pump - Wikipedia

   en.wikipedia.org/wiki/Hand_pump

   The height to which a hand pump will lift is governed by the ability of the pump and the operator to lift the weight in the delivery pipe. Thus the same pump and operator will be able to achieve a greater lift with a smaller diameter pipe than they could with a larger diameter pipe.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [ 15 ] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size.