When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Flap (aeronautics) - Wikipedia

    en.wikipedia.org/wiki/Flap_(aeronautics)

    A flap is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight. Flaps are usually mounted on the wing trailing edges of a fixed-wing aircraft. Flaps are used to reduce the take-off distance and the landing distance. Flaps also cause an increase in drag so they are retracted when not needed.

  3. Flight control surfaces - Wikipedia

    en.wikipedia.org/wiki/Flight_control_surfaces

    Flaps raise the maximum lift coefficient of the aircraft and therefore reduce its stalling speed. [5] They are used during low speed, high angle of attack flight including take-off and descent for landing. Some aircraft are equipped with "flaperons", which are more commonly called "inboard ailerons" [citation needed]. These devices function ...

  4. Leading-edge droop flap - Wikipedia

    en.wikipedia.org/wiki/Leading-edge_droop_flap

    Droop flaps function with other high-lift devices on an aircraft to increase the camber of the wing and reduce the stalling speed.On the Airbus A380, the first stage of lift device selection deploys the droop flaps (called droop noses by Airbus) and leading-edge slats located further out on the wing; with the main flaps starting to extend when the second stage is selected.

  5. Blown flap - Wikipedia

    en.wikipedia.org/wiki/Blown_flap

    Ball-Bartoe Jetwing used for blown-wing research. Note the "augmentor", intended to direct the discharged airflow over the wingWilliams [8] states some flap blowing tests were done at the Royal Aircraft Establishment before the Second World War, and that extensive tests were done during the war in Germany including flight tests with Arado Ar 232, Dornier Do 24 and Messerschmitt Bf 109 aircraft.

  6. High-lift device - Wikipedia

    en.wikipedia.org/wiki/High-lift_device

    The triple-slotted trailing edge flaps are well displayed and the Krueger flaps on the leading edge also are visible. In aircraft design and aerospace engineering, a high-lift device is a component or mechanism on an aircraft's wing that increases the amount of lift produced by the wing. The device may be a fixed component, or a movable ...

  7. Landing - Wikipedia

    en.wikipedia.org/wiki/Landing

    Landing is accomplished by slowing down and descending to the runway. This speed reduction is accomplished by reducing thrust and/or inducing a greater amount of drag using flaps, landing gear or speed brakes. When a fixed-wing aircraft approaches the ground, the pilot will move the control column back to execute a flare or round-out.

  8. Door falls off airplane, forcing emergency landing in South ...

    www.aol.com/door-falls-off-airplane-forcing...

    A South Carolina flight made an emergency landing shortly after takeoff Tuesday — because a door fell off the small plane. The single-engine aircraft, a Diamond DA40, declared an emergency after ...

  9. Krueger flap - Wikipedia

    en.wikipedia.org/wiki/Krueger_flap

    Krueger flaps deployed from the leading edge of a Boeing 747 (top left and right in photo). Krueger flaps, or Krüger flaps, are lift enhancement devices that may be fitted to the leading edge of an aircraft wing. Unlike slats or droop flaps, the main wing upper surface and its leading edge is not changed. Instead, a portion of the lower wing ...