Search results
Results From The WOW.Com Content Network
First-order hold (FOH) is a mathematical model of the practical reconstruction of sampled signals that could be done by a conventional digital-to-analog converter (DAC) and an analog circuit called an integrator. For FOH, the signal is reconstructed as a piecewise linear approximation to the original
The AS-Interface is a single-master system, this means a master device exchanges the input and output data with all configured devices. The transmission medium is an unshielded two-wire yellow flat cable. The cable is used for signal transmission and at the same time for power supply (30 V).
AI is an analog input, AO — an analog output, C — a control signal. Sample times. Sample and hold. A sample-and-hold integrated circuit (Tesla MAC198) In electronics, a sample and hold (also known as sample and follow) circuit is an analog device that samples (captures, takes) the voltage of a continuously varying analog signal and holds ...
A signaling protocol is a type of communications protocol for encapsulating the signaling between communication endpoints and switching systems to establish or terminate a connection and to identify the state of connection. The following is a list of signaling protocols: ALOHA; Digital Subscriber System No. 1 (EDSS1) Dual-tone multi-frequency ...
Bidirectional communication with two unidirectional lines; Point-to-point or multi-slave networks; Maximum user data rate, transmission data depending on driver and line of e.g. RS-422: 10 MHz, 1 km; LVDS: 100 Mbit/s; Independent of the applied physical layer; CRC secured communication (sensor data and control data secured separately) [8]
Until the early 1980s the majority of servo drive systems used to control motion in industrial machinery were based upon analog electronics.The accepted interface to control such devices was an analog voltage signal, where polarity represented the desired direction of motion, and magnitude represented the desired speed or torque.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
The Inter-Control Center Communications Protocol (ICCP or IEC 60870-6/TASE.2) [3] is being specified by utility organizations throughout the world to provide data exchange over wide area networks (WANs) between utility control centers, utilities, power pools, regional control centers, and Non-Utility Generators.