Ad
related to: signs of bad fuel injectors
Search results
Results From The WOW.Com Content Network
[5] [6] Paints, paint solvents, grease, and fuel oils (diesel, paraffin, and gasoline) are the substances that are injected the most frequently, but reports of injecting water, air, cement, and animal vaccines have also been made. [7] [8]
Some fuel injection computers interpret "pumping" the throttle to indicate a flooded engine, and alter the fuel-air mixture accordingly. In a carbureted engine equipped with an accelerator pump (which advances fuel flow to match air ingestion under rapid throttle acceleration), "pumping" the throttle will force excess fuel into the engine ...
Vapor lock is a problem caused by liquid fuel changing state to vapor while still in the fuel delivery system of gasoline-fueled internal combustion engines.This disrupts the operation of the fuel pump, causing loss of feed pressure to the carburetor or fuel injection system, resulting in transient loss of power or complete stalling.
The fuel injectors are wired in parallel, and are supplied with Constant System Voltage. The ECU switches the earth/ground on and off to control duration. All injectors operate at the same time (simultaneously, rather than sequentially) each crankshaft revolution; two complete revolutions being needed for each cylinder to receive the correct ...
Diesel engine runaway is an occurrence in diesel engines, in which the engine draws extra fuel from an unintended source and overspeeds at higher and higher RPM, producing up to ten times the engine's rated output until destroyed by mechanical failure or bearing seizure due to a lack of lubrication. [1]
The fuel injector is effectively a spray nozzle that performs the final stage in the delivery of fuel into the engine. The injector is located in the combustion chamber, inlet manifold or – less commonly – the throttle body. Fuel injectors which also control the metering are called injection valves, while injectors that perform all three ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The MIL will also illuminate if the engine has been cranked but failed to start after returning the ignition to "on". In most modern vehicles this is usually due to not giving the engine enough cranking time to start. In pre-fuel injection years many cranking attempts were sometimes required to start the car.