When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Lightning (connector) - Wikipedia

   en.wikipedia.org/wiki/Lightning_(connector)

   Apple Lightning to USB-A cable. Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [23] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.

3. Thunderbolt (interface) - Wikipedia

   en.wikipedia.org/wiki/Thunderbolt_(interface)

   However, 40 Gbit/s on copper required either active cables, or short (initially 0.5 m (1.6 ft), later 0.8 m (3 ft)) passive cables. Passive copper cables exceeding 0.8 m (3 ft) are limited to 20 Gbit/s. Despite that limit, passive cables provide USB 3 (20 Gbit/s) backward compatibility, while active cables support only USB 2.0 (480 Mbit/s).

4. USB-C - Wikipedia

   en.wikipedia.org/wiki/USB-C

   Whereas earlier USB cables had a host end A and a peripheral device end B, a USB-C cable connects either way; and for interoperation with older equipment, there are cables with a Type-C plug at one end and either a Type-A (host) or a Type-B (peripheral device) plug at the other. The designation "C" refers only to the connector's physical ...

5. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The USB 3.0 Micro-B plug effectively consists of a standard USB 2.0 Micro-B cable plug, with an additional 5 pins plug "stacked" to the side of it. In this way, cables with smaller 5 pin USB 2.0 Micro-B plugs can be plugged into devices with 10 contact USB 3.0 Micro-B receptacles and achieve backward compatibility.

6. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   Many USB bridge / data transfer cables are still USB 2.0, but there are also a number of USB 3.0 transfer cables. Despite USB 3.0 being 10 times faster than USB 2.0, USB 3.0 transfer cables are only 2 to 3 times faster given their design. [clarification needed] The USB 3.0 specification introduced an A-to-A cross-over cable without power for ...

7. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   The USB OTG and Embedded Host Supplement to the USB 2.0 specification introduced three new communication protocols: . Attach Detection Protocol (ADP): Allows an OTG device, embedded host or USB device to determine attachment status in the absence of power on the USB bus, enabling both insertion-based behavior and the capability to display attachment status.