Ads
related to: frequency modulation on pulse radar detector
Search results
Results From The WOW.Com Content Network
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.
Radar Pulse Train. The carrier is an RF signal, typically of microwave frequencies, which is usually (but not always) modulated to allow the system to capture the required data. In simple ranging radars, the carrier will be pulse modulated and in continuous wave systems, such as Doppler radar, modulation may not be required
Pulse Doppler radar may have 50 or more pulses between the radar and the reflector. Pulse Doppler relies on medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz. Each transmit pulse is separated by 5 km to 50 km distance. Range and speed of the target are folded by a modulo operation produced by the sampling process. True range is ...
Pulse-Doppler radar for aircraft detection has two modes. Scan; Track; Scan mode involves frequency filtering, amplitude thresholding, and ambiguity resolution. Once a reflection has been detected and resolved, the pulse-Doppler radar automatically transitions to tracking mode for the volume of space surrounding the track.
The effect can be reduced or eliminated by operating on more than one frequency or using modulation techniques like pulse compression that change the frequency over the period of a pulse. In these cases, it is unlikely that the pattern of reflections from the target causes the same destructive interference at two different frequencies.
Early Doppler radars included CW, but these quickly led to the development of frequency modulated continuous wave radar, which sweeps the transmitter frequency to encode and determine range. With the advent of digital techniques, Pulse-Doppler radars (PD) became light enough for aircraft use, and Doppler processors for coherent pulse radars ...
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar. In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
The radar mile is the time it takes for a radar pulse to travel one nautical mile, reflect off a target, and return to the radar antenna. Since a nautical mile is defined as 1,852 m, then dividing this distance by the speed of light (299,792,458 m/s), and then multiplying the result by 2 yields a result of 12.36 μs in duration.