Search results
Results From The WOW.Com Content Network
Gear inches is one way of measuring the gear ratio(s) of a bicycle, so that different gears and different bicycles can be compared in a consistent manner. Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent ( direct-drive ) gearing.
One standard option for the Brompton folding bicycle is to use a 3-speed hub gear (roughly a 30% difference between gear ratios) in combination with a 2-speed derailleur gear (roughly a 15% difference) to give 6 distinct gear ratios; this is an example of half-step gearing. Some Brompton suppliers offer a 2-speed chainring 'Mountain Drive' as ...
Profile of a spur gear Notation and numbering for an external gear Notation and numbering for an internal gear. The tooth surface (flank) forms the side of a gear tooth. [1] It is convenient to choose one face of the gear as the reference face and to mark it with the letter “I”. The other non-reference face might be termed face “II”.
Notice that these family names do not give the exact shift ratios: the 2:1 shift ratio is in fact about 1.7 (Or 1.9 on the Dura Ace series up to 7400) rather than 2, and the native SRAM shift ratio is about 1.1. The family names of these standards are reversed by some in actuation ratio notation as opposed to that of the more common shift ratio.
A dragstrip is a facility for conducting automobile and motorcycle acceleration events such as drag racing. Although a quarter mile (1320 feet, 402 m) is the best known measure for a drag track, many tracks are eighth mile (201 m) tracks, and the premiere classes will run 1,000 foot (304.8 m) races.
Meshing of two spur gears with involute external teeth. z 1 = 20, z 2 = 50, α = 20°, x 1 = x 2 = 0, ISO 53:1998. The lower (green) gear is the driving one. The line of contact, which is the locus of all teeth contact points, is shown in blue. The contact points are highlighted with bold black dots; either one pair or two pairs of teeth can be ...
Spur gear. Spur gears or straight-cut gears are the simplest type of gear. They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation. Looking down the length of the shaft, a tooth's cross section is ...
'Rollout' is the distance travelled by a vehicle before the timing lights on a drag strip are triggered. … can affect the final run time by up to 0.3 of a second. … important to discount this first foot of movement from the final run time, to ensure that the run time captured by the GPS data logger is as close as possible to the official ...