Search results
Results From The WOW.Com Content Network
For example, if the load power factor were as low as 0.7, the apparent power would be 1.4 times the real power used by the load. Line current in the circuit would also be 1.4 times the current required at 1.0 power factor, so the losses in the circuit would be doubled (since they are proportional to the square of the current).
η 1, s 1, PF 1, Φ 1,: Efficiency, slip, power factor, PF angle at operating current; AB: Represents rotor power input, which divided by synchronous speed equals starting torque. The circle diagram is drawn using the data obtained from no load and either short-circuit or, in case of machines, blocked rotor tests by fitting a half-circle in ...
Reactive power needs to be generated and distributed through a circuit to provide sufficient real power to enable processes to run. Reactive power increases significantly with increasing voltage as the reactance of equipment increases. Correcting this with voltage optimisation will therefore lead to a reduction in reactive power and improvement ...
The basic theory for how FACTs devices affect the AC system is based on analyzing how power transfers between two points in an AC system. This is particularly relevant to how an AC electrical grid functions, as the grid has numerous nodes (substations) that lack sources or loads.
A power conditioner (also known as a line conditioner or power line conditioner) is a device intended to improve the quality of the power that is delivered to electrical load equipment. The term most often refers to a device that acts in one or more ways to deliver a voltage of the proper level and characteristics to enable load equipment to ...
Four circuits are shown. Two additional circuits are obscured by trees on the far right. The entire 6809 MW [1] nameplate generation capacity of the dam is accommodated by these six circuits. Electric power transmission is the bulk movement of electrical energy from a generating site, such as a power plant, to an electrical substation.
In the circuits of Fig. 1 and Fig. 2, the output voltage of importance is the potential from the collector of Q 3 to ground. The measure of that independence is the output impedance of the circuit, the ratio of a change in output voltage to the change in current it causes.
The fixed speed wind turbines without a power converter (also known as "Type 1" and "Type 2" [5]) cannot be used for voltage control. They simply absorb the reactive power (like any typical induction machine), so a switched capacitor bank is usually used to correct the power factor to unity. [7] Capability curve of a photovoltaic generator