Search results
Results From The WOW.Com Content Network
A number of materials contract on heating within certain temperature ranges; this is usually called negative thermal expansion, rather than "thermal contraction".For example, the coefficient of thermal expansion of water drops to zero as it is cooled to 3.983 °C (39.169 °F) and then becomes negative below this temperature; this means that water has a maximum density at this temperature, and ...
For a single component system, the "standard" three parameters are the isothermal compressibility , the specific heat at constant pressure , and the coefficient of thermal expansion . For example, the following equations are true:
The laws of thermodynamics imply the following relations between these two heat capacities (Gaskell 2003:23): = = Here is the thermal expansion coefficient: = is the isothermal compressibility (the inverse of the bulk modulus):
is pressure, temperature, volume, entropy, coefficient of thermal expansion, compressibility, heat capacity at constant volume, heat capacity at constant pressure. Maxwell's relations are a set of equations in thermodynamics which are derivable from the symmetry of second derivatives and from the definitions of the thermodynamic potentials .
Increased thermal vibrations produce thermal expansion characterized by the coefficient of thermal expansion (CTE) that is the gradient of the graph of dimensional change versus temperature. CTE depends upon thermal transitions such as the glass transition. CTE of the glassy state is low, while at the glass transition temperature (Tg) increased ...
Since the isothermal compressibility is positive for nearly all phases, and the square of thermal expansion coefficient is always either a positive quantity or zero, the specific heat at constant pressure is nearly always greater than or equal to specific heat at constant volume: ,,.
Negative and positive thermal expansion hereby compensate each other to a certain amount if the temperature is changed. Tailoring the overall thermal expansion coefficient (CTE) to a certain value can be achieved by varying the volume fractions of the different materials contributing to the thermal expansion of the composite. [8] [20]
Thermal conduction rate, thermal current, thermal/heat flux, thermal power transfer P = / W ML 2 T −3: Thermal intensity I = / W⋅m −2: MT −3: Thermal/heat flux density (vector analogue of thermal intensity above) q