Search results
Results From The WOW.Com Content Network
The type of jet engine used to explain the conversion of fuel into thrust is the ramjet.It is simpler than the turbojet which is, in turn, simpler than the turbofan.It is valid to use the ramjet example because the ramjet, turbojet and turbofan core all use the same principle to produce thrust which is to accelerate the air passing through them.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
A combustor is a component or area of a gas turbine, ramjet, or scramjet engine where combustion takes place. It is also known as a burner, burner can, combustion chamber or flame holder. In a gas turbine engine, the combustor or combustion chamber is fed high-pressure air by the compression system. The combustor then heats this air at constant ...
The combustion chamber was connected to the compressor outlet by a very large single spiral duct giving the engine an asymmetrical appearance. Whittle designed the centrifugal compressor to develop about 4:1 pressure ratio when, as far as he was aware, the best previously demonstrated performance in a single stage was about 2.5:1.
These values are significant in the design of combustion systems. For example, if a turbojet combustion chamber has a maximum temperature of T 0 * = 2000 K, T 0 and M at the entrance to the combustion chamber must be selected so thermal choking does not occur, which will limit the mass flow rate of air into the engine and decrease thrust.
The combustion chamber in gas turbines and jet engines (including ramjets and scramjets) is called the combustor. The combustor is fed with high pressure air by the compression system, adds fuel and burns the mix and feeds the hot, high pressure exhaust into the turbine components of the engine or out the exhaust nozzle.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Closing the valve too quickly while trying to reduce power output could cause a lean die-out, where the airflow through the engine blows the flame out of the combustion chamber and extinguishes it. Adding fuel too quickly to increase power can damage the turbines due to excessive heat, or the sudden rise in combustion chamber pressure may cause ...