Search results
Results From The WOW.Com Content Network
TIP TIG welding torch. TIP TIG is a subset of gas tungsten arc welding (GTAW), using a mechanism called filler wire agitation to enhance molten weld pool dynamics. This agitation has been found to enhance the weld puddle fluidity and release evolving gases, reducing the chances of inclusions and porosity, and also separate impurities.
A transformer-style welding power supply converts the moderate voltage and moderate current electricity from the utility mains (typically 230 or 115 VAC) into a high current and low voltage supply, typically between 17 and 45 (open-circuit) volts and 55 to 590 amperes.
GTAW weld area. Manual gas tungsten arc welding is a relatively difficult welding method, due to the coordination required by the welder. Similar to torch welding, GTAW normally requires two hands, since most applications require that the welder manually feed a filler metal into the weld area with one hand while manipulating the welding torch in the other.
Welding consumables - Wire electrodes and weld deposits for gas shielded metal arc welding of non alloy and fine grain steels - Classification CAN/CSA-W117.2-12: Safety in welding, cutting, and allied processes G40.20-13/G40.21-13: General requirements for rolled or welded structural quality steel/ Structural quality steel W178.1-14
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
“Safety concerns about wiring systems in airplanes were brought to the forefront of public attention by a midair explosion in 1996 involving a 747 airplane. Ignition of flammable vapors in the fuel tank was the probable cause of that fatal accident, and the most likely source was a wiring failure that allowed a spark to enter the fuel tank.
The typical GMAW welding gun has a number of key parts—a control switch, a contact tip, a power cable, a gas nozzle, an electrode conduit and liner, and a gas hose. The control switch, or trigger, when pressed by the operator, initiates the wire feed, electric power, and the shielding gas flow, causing an electric arc to be struck.
Orbital welding has almost always exclusively been carried out by the Tungsten Inert Gas (TIG / GTAW) technique using non-consumable electrodes, with additional cold-wire feed where necessary. The easy control of heat input makes TIG-welding the ideal welding method for fully orbital welding of tubes with specialist orbital welding heads, that ...