When.com Web Search

  1. Ads

    related to: what are monobloc taps good for working on concrete pipe for sale

Search results

  1. Results From The WOW.Com Content Network
  2. Falsework - Wikipedia

    en.wikipedia.org/wiki/Falsework

    The illustrations are of modern pipe-column falsework, used to support the formwork for a post-tensioned reinforced concrete flyover connector for the eastern span replacement of the San Francisco-Oakland Bay Bridge. When the supports are complete, wood beams and plywood or reusable metal forms will be placed, reinforcing and tenon conduits ...

  3. Prestressed concrete cylinder pipe - Wikipedia

    en.wikipedia.org/wiki/Prestressed_concrete...

    Prestressed concrete cylinder pipe (PCCP) is a common variety of large-diameter concrete pressure pipe used for transporting water and wastewater. PCCP is typical manufactured according to the American Water Works Association (AWWA) standard C304. [ 1 ]

  4. Cement-mortar lined ductile iron pipe - Wikipedia

    en.wikipedia.org/wiki/Cement-mortar_lined...

    Cement-mortar lined ductile iron pipe is a ductile iron pipe with cement lining on the inside surface, and is commonly used for water distribution. Cement-mortar lined ductile iron pipe is governed by standards set forth by DIPRA ( Ductile Iron Pipe Research Association ), and was first used in 1922 in Charleston, South Carolina .

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

  6. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...

  7. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors.