Search results
Results From The WOW.Com Content Network
A tie in building construction is an element in tension rather than compression and most collar beams are designed to work in compression to keep the rafters from sagging. [2] [3] A collar near the bottom of the rafters may replace a tie beam and be designed to keep the rafters from spreading, thus are in tension: these are correctly called a ...
The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs. In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam. There are two main types of timber roof trusses: closed, in which the bottom chord is ...
A. section view, B. longitudinal view, C. curved brace, D. crown post, E. cambered tie beam, F. collar plate, R collar beam. A crown post is a term in traditional timber framing for a post in roof framing which stands on a tie beam or collar beam and supports a collar plate. [1]
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Rafter ties are designed to tie together the bottoms of opposing rafters on a roof, to resist the outward thrust where the roof meets the house ceiling and walls. This helps keep walls from spreading due to the weight of the roof and anything on it, notably wet snow. In many or most homes, the ceiling joists also serve as the rafter ties. When ...
A single, central post in a roof truss in tension between the rafters and a tie beam (bottom chord), or 2) (U.S.) A short of the tie beam only supporting the rafters via struts. 3) (U.K.) A king post specifically carries a ridge beam otherwise is called a king strut. "King post" was formerly used to describe a crown post in the U. K., but no ...
Wilmington artist Ben Billingsley points out works going into the Cameron Art Museum's exhibit "Closer to Home," which opens Nov. 16. It will be the largest-ever exhibit of work from the museum's ...
The king post is the central, vertical member of the truss. Crown posts in the nave roof at Old Romney church, Kent, England. A king post (or king-post or kingpost) is a central vertical post used in architectural or bridge designs, working in tension to support a beam below from a truss apex above (whereas a crown post, though visually similar, supports items above from the beam below).