When.com Web Search

  1. Ad

    related to: pressure generator for calibration system requirements manual download free

Search results

  1. Results From The WOW.Com Content Network
  2. IEC 61000-4-2 - Wikipedia

    en.wikipedia.org/wiki/IEC_61000-4-2

    The publication describes requirements, levels and test methods to achieve immunity compliance of an electronic product. The purpose is to create a reproducible ground for product compliance and the standard defines: ranges, levels, test equipment, setups, procedures, calibrations, generator waveforms and general uncertainties.

  3. Pressure Equipment Directive (EU) - Wikipedia

    en.wikipedia.org/wiki/Pressure_Equipment...

    The Pressure Equipment Directive (PED) 2014/68/EU (formerly 97/23/EC) [1] of the EU sets out the standards for the design and fabrication of pressure equipment ("pressure equipment" means steam boilers, pressure vessels, piping, safety valves and other components and assemblies subject to pressure loading) generally over one liter in volume and having a maximum pressure more than 0.5 bar gauge.

  4. Deadweight tester - Wikipedia

    en.wikipedia.org/wiki/Deadweight_tester

    A dead weight tester (DWT) is a calibration standard method that uses a piston cylinder on which a load is placed to make an equilibrium with an applied pressure underneath the piston. Deadweight testers are secondary standards which means that the pressure measured by a deadweight tester is defined through other quantities: length, mass and ...

  5. EN 13445 - Wikipedia

    en.wikipedia.org/wiki/EN_13445

    EN 13445 was introduced in 2002 as a replacement for national pressure vessel design and construction codes and standards in the European Union and is harmonized [1] with the Pressure Equipment Directive (2014/68/EU or "PED"). New updated versions of all parts were published between 2009 and 2012.

  6. List of IEC standards - Wikipedia

    en.wikipedia.org/wiki/List_of_IEC_standards

    IEC 62351 Power System Control and Associated Communications – Data and Communication Security; IEC 62353 Medical electrical equipment – Recurrent test and test after repair of medical electrical equipment; IEC/TR 62357 Power system control and associated communications – Reference architecture for object models, services and protocols

  7. Calibration - Wikipedia

    en.wikipedia.org/wiki/Calibration

    As an example, a manual process may be used for calibration of a pressure gauge. The procedure requires multiple steps, [ 12 ] to connect the gauge under test to a reference master gauge and an adjustable pressure source, to apply fluid pressure to both reference and test gauges at definite points over the span of the gauge, and to compare the ...

  8. High-integrity pressure protection system - Wikipedia

    en.wikipedia.org/wiki/High-integrity_pressure...

    A high-integrity pressure protection system (HIPPS) is a type of safety instrumented system (SIS) designed to prevent over-pressurization of a plant, such as a chemical plant or oil refinery. The HIPPS will shut off the source of the high pressure before the design pressure of the system is exceeded, thus preventing loss of containment through ...

  9. Load bank - Wikipedia

    en.wikipedia.org/wiki/Load_bank

    A resistive load bank, therefore, removes energy from the complete system: load bank from generatorgenerator from prime mover—prime mover from fuel. Additional energy is removed as a consequence of resistive load bank operation: waste heat from coolant, exhaust and generator losses and energy consumed by accessory devices.

  1. Ad

    related to: pressure generator for calibration system requirements manual download free