Search results
Results From The WOW.Com Content Network
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
Link-local addresses and the loopback address have link-local scope, which means they can only be used on a single directly attached network. All other addresses (including unique local addresses ) have global (or universal ) scope, which means they are potentially globally routable and can be used to connect to addresses with global scope ...
Once a unique link-local address is established, the IPv6 host determines whether the LAN is connected on this link to any router interface that supports IPv6. It does so by sending out an ICMPv6 router solicitation message to the all-routers [44] multicast group with its link-local address as source. If there is no answer after a predetermined ...
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [ 2 ] (routable only within the scope of private networks, but not the global IPv6 Internet).
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.
IPv6 hosts are required to support multiple addresses per interface; moreover, every IPv6 host is required to configure a link-local address even when global addresses are available. IPv6 hosts may additionally self-configure additional addresses on receipt of router advertisement messages, thus eliminating the need for a DHCP server. [2]
Interface-local Packets with this destination address may not be sent over any network link, but must remain within the current node; this is the multicast equivalent of the unicast loopback address. ffx2::/16: 224.0.0.0/24: Link-local Packets with this destination address may not be routed anywhere. ffx3::/16: 239.255.0.0/16: Realm-Local scope ...