Ads
related to: 28mm extra deep socketebay.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.
On the female socket, the major key is 4 mm deep at the 6-o'clock position. The width of the major key defines the current rating: 32 A plugs have a narrower 5 mm wide groove, while 16 A plugs have a wider 8 mm groove, and therefore 32 A plugs can be used with 16 A sockets but 16 A plugs cannot be used with 32 A sockets.
A Schuko plug features two round pins of 4.8 mm diameter (19 mm long, centres 19 mm apart) for the line and neutral contacts, plus two flat contact areas on the top and bottom side of the plug for protective earth . The socket (which is often, in error, also referred to as CEE 7/4) has a predominantly circular recess which is 17.5 mm deep with ...
Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw
The screw heads are typically flanged, and may fit into standard Allen hex socket cap screw counterbores molded or machined into parts to be fastened. Compared to Allen hex sockets, the advantages of these bolts include higher torque capability and the lack of a recess to trap water. A disadvantage is the extra cost involved in forming the heads.
The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...