Search results
Results From The WOW.Com Content Network
In electrical circuits, reactance is the opposition presented to alternating current by inductance and capacitance. [1] Along with resistance, it is one of two elements of impedance; however, while both elements involve transfer of electrical energy, no dissipation of electrical energy as heat occurs in reactance; instead, the reactance stores energy until a quarter-cycle later when the energy ...
Summation of the inductive and capacitive coupling coefficients is performed by formula [3] = + +. (8) This formula is derived from the definition (6) and formulas (4) and (7). Note that the sign of the coupling coefficient itself is of no importance. Frequency response of the filter will not change if signs of all the coupling coefficients ...
Resonance occurs when an LC circuit is driven from an external source at an angular frequency ω 0 at which the inductive and capacitive reactances are equal in magnitude. The frequency at which this equality holds for the particular circuit is called the resonant frequency.
The value of each capacitor in farads is the same as the inductance of the associated permeance in henrys. N 1, N 2, and N 3 are the number of turns in the three primary windings. N 4, N 5, and N 6 are the number of turns in the three secondary windings. Φ 1, Φ 2, and Φ 3 are the fluxes in the three vertical elements.
Capacitive current Ic = Q/E = 1523/440 = 3.46 A Capacitive reactance per phase Xc = E/Ic = 127 Ω. Minimum capacitance per phase: C = 1 / (2*π*f*Xc) = 1 / (2 * 3.141 * 60 * 127) = 21 μF. If the load also absorbs reactive power, capacitor bank must be increased in size to compensate. Prime mover speed should be used to generate frequency of 60 Hz:
Inductance is defined as the ratio of the induced voltage to the rate of change of current causing it. [1] It is a proportionality constant that depends on the geometry of circuit conductors (e.g., cross-section area and length) and the magnetic permeability of the conductor and nearby materials. [1]
The stub is made capacitive or inductive according to whether the main line presents an inductive or capacitive impedance, respectively. This is not the same as the actual impedance of the load since the reactive part of the load impedance will be subject to impedance transformer action and the resistive part.
As a result, device admittance is frequency-dependent, and the simple electrostatic formula for capacitance, = , is not applicable. A more general definition of capacitance, encompassing electrostatic formula, is: [ 6 ]