Ads
related to: below grade waterproofing detail products
Search results
Results From The WOW.Com Content Network
Waterproofing a structure from the exterior is the only method the U.S. International Building Code (IBC) recognizes as adequate to prevent structural damage caused by water intrusion. Waterproofing an existing basement begins with excavating to the bottom sides of the footings. Once excavated, the walls are then power washed and allowed to dry.
In construction, a building or structure is waterproofed with the use of membranes and coatings to protect contents and structural integrity. The waterproofing of the building envelope in construction specifications is listed under 07 - Thermal and Moisture Protection within MasterFormat 2004, by the Construction Specifications Institute, and includes roofing and waterproofing materials.
The waterproofing system can be applied to the inside or the outside walls of a basement. [17] When waterproofing existing basements it is much cheaper to waterproof the basement on the inside. Waterproofing on the outside requires the expense of excavation, but does offer a number of advantages for a homeowner over the long term. Among them are:
Bituminous waterproofing systems are designed to protect residential and commercial buildings. Bitumen (asphalt or coal-tar pitch) is a material made up of organic liquids that are highly sticky, viscous , and waterproof. [ 1 ]
Asphalt shingles on a home in Avalon, New Jersey. Two types of base materials are used to make asphalt shingles, organic and fiberglass.Both are made in a similar manner, with an asphalt-saturated base covered on one or both sides with asphalt or modified-asphalt, the exposed surface impregnated with slate, schist, quartz, vitrified brick, stone, [6] or ceramic granules, and the under-side ...
A slab-on-grade or basement floor should be poured over a cross-laminated polyethylene vapor barrier over 4 inches (10 cm) of granular fill to prevent wicking of moisture from the ground and radon gas incursion. Inside a steel building, water vapor will condense whenever it comes into contact with a surface that is below the dew point temperature.