Search results
Results From The WOW.Com Content Network
A large Alexanderson alternator might produce 500 kW of output radio-frequency energy and would be water- or oil-cooled. One such machine had 600 pole pairs in the stator winding, and the rotor was driven at 2170 RPM, for an output frequency near 21.7 kHz. To obtain higher frequencies, higher rotor speeds were required, up to 20,000 RPM.
Automotive alternators are usually belt-driven at 2–3 times crankshaft speed, speeds that could cause a commutator to fly apart in a generator. The alternator runs at various RPM (which varies the frequency) since it is driven by the engine. This is not a problem because the alternating current is rectified to direct current.
The Continental brand name of the six cylinder 3 litre Thielert Diesel, with an output of 300 hp (224 kW) at 2300 rpm. [12] The CD-300 should replace the Safran/SMA diesel engine for the five-seat, single-engine Diamond DA50 from the third quarter of 2020 after a first flight of the combination on 22 March 2019, with a cruise fuel burn of 34.8 ...
At synchronous speed of 1800 RPM, generator will produce no power. When the driving speed is increased to 1860 RPM (typical example), full output power is produced. If the prime mover is unable to produce enough power to fully drive the generator, speed will remain somewhere between 1800 and 1860 RPM range.
Constant speed drive for Boeing 727, made by Sundstrand Corporation. A constant speed drive (CSD) also known as a constant speed generator, is a type of transmission that takes an input shaft rotating at a wide range of speeds, delivering this power to an output shaft that rotates at a constant speed, despite the varying input.
Early automobile generators and alternators had a mechanical voltage regulator using one, two, or three relays and various resistors to stabilize the generator's output at slightly more than 6.7 or 13.4 V to maintain the battery as independently of the engine's rpm or the varying load on the vehicle's electrical system as possible.
Single-phase generator (also known as single-phase alternator) is an alternating current electrical generator that produces a single, continuously alternating voltage. Single-phase generators can be used to generate power in single-phase electric power systems.
Droop speed control is a control mode used for AC electrical power generators, whereby the power output of a generator reduces as the line frequency increases. It is commonly used as the speed control mode of the governor of a prime mover driving a synchronous generator connected to an electrical grid.