Search results
Results From The WOW.Com Content Network
German physicist Heinrich Hertz first demonstrated the existence of radio waves in 1887 using what we now know as a dipole antenna (with capacitative end-loading). On the other hand, Guglielmo Marconi empirically found that he could just ground the transmitter (or one side of a transmission line, if used) dispensing with one half of the antenna, thus realizing the vertical or monopole antenna.
Two element dipole array in front of a one wavelength square reflector used as gain standard The gain of practical array antennas is limited to about 25–30 dB. Two half wave elements spaced a half wave apart and a quarter wave from a reflecting screen have been used as a standard gain antenna with about 9.8 dBi at its design frequency. [ 4 ]
A balun / ˈ b æ l ʌ n / (from "balanced to unbalanced", originally, but now derived from "balancing unit") [1] is an electrical device that allows balanced and unbalanced lines to be interfaced without disturbing the impedance arrangement of either line. [2] A balun can take many forms and may include devices that also transform impedances ...
G5RV Antenna without balun. The G5RV antenna is a dipole with a symmetric resonant [ 1 ] feeder line , which serves as impedance matcher for a 50 Ω coax cable to the transceiver . [ 2 ] [ 3 ]
A coaxial antenna (often known as a coaxial dipole) is a particular form of a half-wave dipole antenna, most often employed as a vertically polarized omnidirectional antenna. History [ edit ]
A log-periodic antenna (LPDA) consists of many dipole elements of decreasing length, all of which are driven. However, because they are different lengths, only one of the many dipoles is resonant at a given frequency, so only one is driven at a time. The dipole that is driven depends on the frequency of the signal.
Consider a Yagi–Uda consisting of a reflector, driven element, and a single director as shown here. The driven element is typically a 1 ⁄ 2 λ dipole or folded dipole and is the only member of the structure that is directly excited (electrically connected to the feedline). All the other elements are considered parasitic. That is, they ...
The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω, non-inductive. This allows the antenna impedance to swing from 400–1,600 Ω over the frequency range intended and thus keep the SWR at the transmitter 2:1 or lower.