Search results
Results From The WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Launch control operates by using an electronic accelerator and a computer program in a drive-by-wire application, and through fuel or spark cut in a mechanical throttle application. The software can control acceleration based on engine specifications to make the car accelerate smoothly and as fast as possible, avoiding spinning of the drive ...
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
The engine management system was first utilized on the Saab B204 and B234 "H" engines to monitor and control the fuel injection system and turbocharging pressure control. The Trionic 5.2 and 5.5 systems utilized the manifold absolute pressure (MAP) sensor and the intake air charge temperature sensor to calculate the fuel injection curves, while ...
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
Traction control system (TCS) actuates brakes or reduces throttle to restore traction if driven wheels begin to spin. Four wheel drive (AWD) with a centre differential. Distributing power to all four wheels lessens the chances of wheel spin. It also suffers less from oversteer and understeer.
Model-based design (MBD) is a mathematical and visual method of addressing problems associated with designing complex control, [1] signal processing [2] and communication systems. It is used in many motion control , industrial equipment, aerospace , and automotive applications.