Ad
related to: single sideband transmitter block diagram
Search results
Results From The WOW.Com Content Network
Amplitude-companded single sideband is a narrowband modulation method using a single sideband with a pilot tone, allowing an expander in the receiver to restore the amplitude that was severely compressed by the transmitter. It offers improved effective range over standard SSB modulation while simultaneously retaining backwards compatibility ...
Independent sideband (ISB) is an AM single sideband mode which is used with some AM radio transmissions. Normally each sideband carries identical information, but ISB modulates two different input signals — one on the upper sideband, the other on the lower sideband. This is used in some kinds of AM stereo (sometimes known as the Kahn system).
SSB, or SSB-AM single-sideband full carrier modulation, is very similar to single-sideband suppressed carrier modulation (SSB-SC). It is used where it is necessary to receive the audio on an AM receiver, while using less bandwidth than with double sideband AM. Due to high distortion, it is seldom used.
In SSB, the carrier is suppressed, significantly reducing the electrical power (by up to 12 dB) without affecting the information in the sideband. This makes for more efficient use of transmitter power and RF bandwidth, but a beat frequency oscillator must be used at the receiver to reconstitute the carrier. If the reconstituted carrier ...
Independent sideband (two sidebands containing different signals) C: Vestigial sideband (e.g. NTSC) D: Combination of AM and FM or PM F: Frequency modulation (e.g. FM broadcast radio) G: Phase modulation: H: Single-sideband modulation with full carrier (e.g. as used by CHU) J: Single-sideband with suppressed carrier (e.g. Shortwave utility and ...
A Compatible sideband transmission, also known as amplitude modulation equivalent (AME) or Single sideband reduced-carrier (SSB-RC), is a type of single sideband RF modulation in which the carrier is deliberately reinserted at a lower level after its normal suppression to permit reception by conventional AM receivers. The general convention is ...
Categorization for signal modulation based on data and carrier types. In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the carrier signal, with a separate signal called the modulation signal that typically contains information to be transmitted. [1]
The High Frequency Global Communications System (HFGCS) is a network of single sideband shortwave transmitters of the United States Air Force which is used to communicate with aircraft in flight, ground stations and some United States Navy surface assets.