Ads
related to: brick shelf angle
Search results
Results From The WOW.Com Content Network
Shelf angles are in reality a horizontal expansion joint which allows growth of the brick below the shelf angle and to allow movement or shrinkage of the frame without putting stresses on the brick veneer. [2] In the United States, common sizes for steel shelf angles include L 3" x 3" x 1/4" and L 4" x 4" x 1/4".In the UK and Europe shelf ...
In brick or stone buildings taller than three stories, however, a shelf angle is usually used to transfer the load of the wall to a hidden, interior steel wall. Flashing is used to cover the space exposed by the shelf angle to help limit the intrusion of water. Where flashing is considered aesthetically unpleasing, a belt course is often used.
Building B also expanded with masonry shelf angle which had suffered severe corrosion from insufficient flashing and weeps, leading to rust, which caused the supported brick course to lift and allow moisture infiltration. This moisture, combined with seasonal freeze-thaw cycles, exacerbated the dislocation of the brick veneer. To address these ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
A mason laying a brick on top of the mortar Bridge over the Isábena river in the Monastery of Santa María de Obarra, masonry construction with stones. Masonry is the craft of building a structure with brick, stone, or similar material, including mortar plastering which are often laid in, bound, and pasted together by mortar.
A single wythe of brick that is not structural in nature is referred to as a masonry veneer. A multiple-wythe masonry wall may be composed of a single type of masonry unit layered to increase its thickness and structural strength, or different masonry units chosen by function, such as an economical concrete block serving a structural purpose ...
The angle of slope varies according to the wood used, purpose of joint and type of work. Typically the slope is 1:6 for softwoods, and a shallower 1:8 slope for hardwoods. Often a slope of 1:7 is used as a compromise. However, a different slope does not affect the strength of the joint in different types of wood. [4]
Thanks to the discontinuity produced by Rumford's brick "smoke shelf", the flow of smoke gases up the chimney became detached from the outside wall at the lip of the shelf. This set up a counter-circulation of outside air which flowed down the backside of the chimney, while a mixture of outside air and smoke flowed up the opposite side.