Ads
related to: cooling tower spray nozzle
Search results
Results From The WOW.Com Content Network
A spray tower (or spray column or spray chamber) is a gas-liquid contactor used to achieve mass and heat transfer between a continuous gas phase (that can contain dispersed solid particles) and a dispersed liquid phase. It consists of an empty cylindrical vessel made of steel or plastic, and nozzles that spray liquid into the vessel.
Spray nozzles can have one or more outlets; a multiple outlet nozzle is known as a compound nozzle. Multiple outlets on nozzles are present on spray balls, which have been used in the brewing industry for many years for cleaning casks and kegs. [2] Spray nozzles range from those for heavy duty industrial uses to light duty spray cans or spray ...
A cooling tower is a device that rejects waste heat to the atmosphere through the ... The water is sprayed through pressurized nozzles near the top of the tower, and ...
Spray nozzle manufacturers all tabulate capacity based on water. Since the specific gravity of a liquid affects its flow rate, the values must be adjusted using the equation below, where Qw is the water capacity and Spg is the specific gravity of the fluid used resulting the volumetric flow rate of the fluid used Qf.
A spray pond is a reservoir in which warmed water (e.g. from a power plant) is cooled before reuse by spraying the warm water with nozzles into the cooler air. Cooling takes place by exchange of heat with the ambient air, involving both conductive heat transfer between the water droplets and the surrounding air and evaporative cooling (which ...
The evaporative cooling within a windtower causes the air in the tower to sink, driving circulation. This is called passive downdraught evaporative cooling (PDEC). It may also be generated using spray nozzles (which have a tendency to get blocked if the water is hard) or cold-water cooling coils (like hydronic underfloor heating in reverse). [5]
Removal efficiency of pollutants is improved by increasing residence time in the scrubber or by the increase of surface area of the scrubber solution by the use of a spray nozzle, packed towers or an aspirator. Wet scrubbers may increase the proportion of water in the gas, resulting in a visible stack plume, if the gas is sent to a stack.
Air-aspirating nozzles use an opening in the cone shaped nozzle to inject air into a stream of water based foam (CAFS/AFFF/FFFP) to make the concentrate "foam up". Most commonly found on foam extinguishers and foam handlines. Swirl nozzles inject the liquid in tangentially, and it spirals into the center and then exits through the central hole ...