Search results
Results From The WOW.Com Content Network
Aluminium oxynitride (marketed under the name ALON by Surmet Corporation [3]) is a transparent ceramic composed of aluminium, oxygen and nitrogen.Aluminium oxynitride is optically transparent (≥80% for 2 mm thickness) in the near-ultraviolet, visible, and mid-wave-infrared regions of the electromagnetic spectrum.
Solid solution strengthening of steel is one of the mechanisms used to enhance the properties of the alloy. Austenitic steels mainly contain chromium, nickel, molybdenum, and manganese. [13] It is being used mostly for cookware, kitchen equipment, and in marine applications for its good corrosion properties in saline environments.
Aluminium oxide (or aluminium(III) oxide) is a chemical compound of aluminium and oxygen with the chemical formula Al 2 O 3.It is the most commonly occurring of several aluminium oxides, and specifically identified as aluminium oxide.
Both quantitative and qualitative tests for solderability exist. [6] The two most common testing methods are the 'dip and look' method and wetting balance analysis.In both of these tests, the soldered pieces undergo an accelerated aging process before being tested for solderability, to take into consideration the time a component was in storage prior to mounting to final assembly.
The porosity eliminates the pipe found in killed steel and increases the yield to approximately 90% by weight. Semi-killed steel is commonly used for structural steel with a carbon content between 0.15 and 0.25% carbon, because it is rolled, which closes the porosity. It is also used for drawing applications. [4] [8] [needs update]
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
The solubility of magnesium is very high in aluminium and reaches a maximum at 450 °C with 14% to 17% depending on the literature reference. At 34.5%, there is a Eutectic with Al 8 Mg 5 (sometimes referred to as Al 3 Mg 2 ), an intermetallic phase ( β {\displaystyle \beta } -phase).
Aluminized steel can be made using a variety of processes, cladding, hot dipping, galvanic coating, metallizing, and calorizing, but the most effective process is hot dipping. The process of hot dipping starts by cleaning the steel, then placing the steel in a bath of Al-11%Si at a temperature of 988K and shaken, then pulled out and air dried. [5]