Ads
related to: satellite splitters for dish equipment parts manual model
Search results
Results From The WOW.Com Content Network
The dish antenna occupies the high frequencies (typically 950 to 1450 MHz), and the TV antenna uses lower television channel frequencies (typically 50 to 870 MHz). In addition, the satellite also gets a DC to low frequency band to power the dish's block converter and select the dish antenna polarization (e.g., voltage signaling or DiSEqC ).
A low-noise block downconverter (LNB) is the receiving device mounted on satellite dishes used for satellite TV reception, which collects the radio waves from the dish and converts them to a signal which is sent through a cable to the receiver inside the building.
The transmission signal of the up-link, of relatively high power (1, 2, or 5 watts for common VSAT equipment) originating from BUC and the very low power received signal power (in the order of μV) coming from the antenna to the LNB receiver unit, in this case are at an angle of 90° relative to each other, are both coupled together at the feed ...
Universal Satellites Automatic Location System (USALS), also known (unofficially) as DiSEqC 1.3, Go X or Go to XX is a satellite dish motor protocol that automatically creates a list of available satellite positions in a motorised satellite dish setup. It is used in conjunction with the DiSEqC 1.2 protocol.
2-way DiSEqC switch 4-way DiSEqC switch with attached coaxial cables.. DiSEqC (/ ˈ d aɪ s ɛ k, d aɪ ˈ s ɛ k s i /; [citation needed] short for Digital Satellite Equipment Control) is a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small [1] dish antenna rotor.
A mixer in the dish-end equipment (an LNB or distribution unit) converts the received signal to the correct user band IF centre frequency for that receiver. [3] The converted transponders of the various users are then combined, and sent via the single coaxial cable to the receivers. The combined signal is tapped or split to reach every user.
a Multiswitch with 16 outputs, the four cables from the Quattro-LNB enter on the left. A multiswitch is a device used with a dual or quattro LNB to distribute satellite TV signals to multiple (usually more than four) receivers from a single dish and LNB.
A satellite modem is not the only device needed to establish a communication channel. Other equipment that is essential for creating a satellite link include satellite antennas and frequency converters. Data to be transmitted are transferred to a modem from data terminal equipment (e.g. a computer).