Search results
Results From The WOW.Com Content Network
Peak pulse power handling, driven by voltage breakdown, is more or less frequency independent for any given size (and can be deduced by assuming ~300 V RMS per mm of inner to outer spacing), but the average power, limited by losses heating the centre conductors, increases approximately with the square root of the operating frequency.
Air cored Microwave connectors The name of a connector (e.g. 1.85) is determined by the diameter in mm of the air dielectric around the centre pin 3.5 and 2.92 mm (sometimes called K) connectors, which also have a 0.9mm centre pin and cross-mate with SMA and offer higher maximum frequency
Various popular RF connectors Electronic symbols for the plug and jack coaxial connectors Time-domain reflectometry shows reflections due to impedance variations in mated RF connectors. An RF connector ( radio frequency connector ) is an electrical connector designed to work at radio frequencies in the multi-megahertz range.
The TNCA connector is a variant of the TNC connector specified in MIL-STD-348 [1] designed to provide an air gap in the dielectric region between the male and female connectors. The female TNCA connector is nearly identically to the standard TNC female connector, while the male TNCA connector provides the air cavity differentiating it from a ...
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
The UHF connector [4] is a name for a fairly common, but old type of threaded RF connector. [5] [6] The connector design was invented in the 1930s for use in the radio industry. [7] [4] It is a widely used standard connector for HF transmission lines on full-sized radio equipment, with BNC connectors predominating for smaller, hand-held ...
The connector family was created by the Quick Lock Formula Alliance, which consists of Huber+Suhner, Radiall, Rosenberger Hochfrequenztechnik, and Amphenol. QMA [1] and QN [2] connectors are the quick lock version of SMA and N connectors. This design can save much handling time because it allows quick mating and demating without tools.