Search results
Results From The WOW.Com Content Network
Neoprene's burn point is around 260 °C (500 °F). [21] In its native state, neoprene is a very pliable rubber-like material with insulating properties similar to rubber or other solid plastics. Neoprene foam is used in many applications and is produced in either closed-cell or open-cell form.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Stamped concrete is an architectural concrete that has a superior surface finish. After a concrete floor has been laid, floor hardeners (can be pigmented) are impregnated on the surface and a mold that may be textured to replicate a stone / brick or even wood is stamped on to give an attractive textured surface finish.
All concrete structures will crack to some extent, due to shrinkage and tension. Concrete which is subjected to long-duration forces is prone to creep. The density of concrete varies, but is around 2,400 kilograms per cubic metre (150 lb/cu ft). [1] Reinforced concrete is the most common form of concrete.
The first expanded polystyrene ICF Wall forms were developed in the late 1960s with the expiration of the original patent and the advent of modern foam plastics by BASF. [citation needed] Canadian contractor Werner Gregori filed the first patent for a foam concrete form in 1966 with a block "measuring 16 inches high by 48 inches long with a tongue-and-groove interlock, metal ties, and a waffle ...
Although it may have been discovered earlier, chloroprene was largely developed by DuPont during the early 1930s, specifically with the formation of neoprene in mind. [4] The chemists Elmer K. Bolton , Wallace Carothers , Arnold Collins and Ira Williams are generally accredited with its development and commercialisation although the work was ...
Waterstops are manufactured from a variety of materials depending on the functionality and their intended use. The most common types are: Waterstops made from extruded plastics such as flexible polyvinyl chloride PVC, polyethylene (PE) or thermoplastic vulcanized rubber (TPV); formed metal such as stainless steel, copper, or carbon steel - with or without polymeric coatings; extruded ...
For removable forms, once the concrete has been poured into formwork and has set (or cured), the formwork is struck or stripped to expose the finished concrete. The time between pouring and stripping depends on the job specifications, which include the cure required, and whether the form is supporting any weight; it is usually at least 24 hours ...