When.com Web Search

  1. Ads

    related to: 1000 gauge plastic sheeting screwfix material

Search results

  1. Results From The WOW.Com Content Network
  2. Visqueen - Wikipedia

    en.wikipedia.org/wiki/Visqueen

    Visqueen is a brand of polyethylene plastic sheeting (typically low-density polyethylene) produced by British Polythene Industries Limited.It is the registered trade mark of British Polythene Limited in numerous countries throughout the world.

  3. Shrink wrap - Wikipedia

    en.wikipedia.org/wiki/Shrink_wrap

    Shrink wrap, also shrink film, is a material made up of polymer plastic film. When heat is applied, it shrinks tightly over whatever it is covering. ... D882 Standard ...

  4. Plastic film - Wikipedia

    en.wikipedia.org/wiki/Plastic_film

    Plastic film is a thin continuous polymeric material. Thicker plastic material is often called a "sheet". Thicker plastic material is often called a "sheet". These thin plastic membranes are used to separate areas or volumes, to hold items, to act as barriers, or as printable surfaces.

  5. Tarpaulin - Wikipedia

    en.wikipedia.org/wiki/Tarpaulin

    An improvised tent using polytarp as a fly Abandoned homeless shelter using plastic tarp. A tarpaulin (/ t ɑːr ˈ p ɔː l ɪ n / tar-PAW-lin, [1] also US: / ˈ t ɑːr p ə l ɪ n / [2]) or tarp is a large sheet of strong, flexible, water-resistant or waterproof material, often cloth such as canvas or polyester coated with polyurethane, or made of plastics such as polyethylene.

  6. Thousandth of an inch - Wikipedia

    en.wikipedia.org/wiki/Thousandth_of_an_inch

    The thickness of items such as paper, film, foil, wires, paint coatings, latex gloves, plastic sheeting, and fibers For example, most plastic ID cards are about 30 thou (0.76 mm) in thickness. Card stock thickness in the United States, where mils are also called points. [2] Gauge (diameter) of strings in stringed instruments [3] [4]

  7. Thermoforming - Wikipedia

    en.wikipedia.org/wiki/Thermoforming

    A sheet of hot plastic will be placed on top and the bed sealed, pulling the plastic down over the mold. In the most common method of high-volume, continuous thermoforming of thin-gauge products, plastic sheet is fed from a roll or from an extruder into a set of indexing chains that incorporate pins, or spikes, that pierce the sheet and ...