Search results
Results From The WOW.Com Content Network
The dying gasp message will end the session and a new session will be able to be made as soon as power returns and the modem retrains. [ citation needed ] Dying gasp is referenced in section 7.1.2.5.3 of ITU-T Recommendation G.991.2 (12/2003) as the Power Status bit.
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
Three network interface widgets (2 Ethernet and 1 WiFi) showing two network interfaces being up, one being down with no cable plugged in (hence: "no carrier"), underlined in red. NO CARRIER (capitalized) is a word code transmitted from a modem to its attached device (typically a computer ), indicating the modem is not (or no longer) connected ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
A link budget is an accounting of all of the power gains and losses that a communication signal experiences in a telecommunication system; from a transmitter, through a communication medium such as radio waves, cable, waveguide, or optical fiber, to the receiver.
1. Launch AOL Dialer. 2. Enter your username or email address and password. 3. Click Sign On. 4. Add your location name and connection type. 5. Click Next twice. 6. Select your dialing options.
The electric field strength at a specific point can be determined from the power delivered to the transmitting antenna, its geometry and radiation resistance. Consider the case of a center-fed half-wave dipole antenna in free space, where the total length L is equal to one half wavelength (λ/2).
In telecommunications, insertion loss is the loss of signal power resulting from the insertion of a device in a transmission line or optical fiber and is usually expressed in decibels (dB). If the power transmitted to the load before insertion is P T and the power received by the load after insertion is P R, then the insertion loss in decibels ...