Search results
Results From The WOW.Com Content Network
Where a system (such as a modem) involves round-trip analog-to-digital processing, a distinction is made between analog loopback, where the analog signal is looped back directly, and digital loopback, where the signal is processed in the digital domain before being re-converted to an analog signal and returned to the source.
An ICD is the umbrella document over the system interfaces; examples of what these interface specifications should describe include: The inputs and outputs of a single system, documented in individual SIRS (Software Interface Requirements Specifications) and HIRS (Hardware Interface Requirements Specifications) documents, would fall under "The Wikipedia Interface Control Document".
umount /home/you/dir # or, after finding the associated loop number by e.g. mount | grep "/home/you/dir" # or losetup -a | grep example.img umount /dev/loop<N> At a lower level application programming interface , the association and disassociation of a file with a loop device is performed with the ioctl system call on a loop device.
UDP is a simple message-oriented transport layer protocol that is documented in RFC 768.Although UDP provides integrity verification (via checksum) of the header and payload, [4] it provides no guarantees to the upper layer protocol for message delivery and the UDP layer retains no state of UDP messages once sent.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Interface-local Packets with this destination address may not be sent over any network link, but must remain within the current node; this is the multicast equivalent of the unicast loopback address. ffx2::/16: 224.0.0.0/24: Link-local Packets with this destination address may not be routed anywhere. ffx3::/16: 239.255.0.0/16: Realm-Local scope ...
Microsoft Visio: No No Pro versions [43] Plugin No No No Modelio: Yes Partial Unknown Yes [44] Yes [45] No No Papyrus: Yes Yes Yes [46] Unknown Unknown No Unknown Rhapsody: Yes Partial UML v1 Yes [47] Unknown Yes [48] Unknown Software Ideas Modeler: Yes Yes Unknown Yes Yes No Unknown System Architect: Yes Yes Unknown No Yes Yes