Ads
related to: evaporative vent solenoid chevrolet
Search results
Results From The WOW.Com Content Network
The vapors which are displaced from the fuel tank by the incoming fuel are routed via the vapor vent line to the canister and are absorbed by activated carbon. These canisters are made of either steel or plastic. The size of this canister is tailored to accommodate expected evaporative emissions.
Evaporative emissions are the result of gasoline vapors escaping from the vehicle's fuel system. Since 1971, all U.S. vehicles have had fully sealed fuel systems that do not vent directly to the atmosphere; mandates for systems of this type appeared contemporaneously in other jurisdictions.
Blow-by, as it is often called, is the result of combustion material from the combustion chamber "blowing" past the piston rings and into the crankcase. These blow-by gases, if not ventilated, inevitably condense and combine with the oil vapor present in the crankcase, forming oil sludge.
The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.
The 4L80-E uses two shift solenoids, initially called Shift Solenoid A and Shift Solenoid B; they were later changed to comply with OBD-II regulations to 1-2 shift solenoid and 2-3 shift solenoid. By activating and deactivating the solenoids in a predetermined pattern by the PCM, four distinct gear ratios can be achieved.
Pumped air injection systems use a vane pump called the air pump, AIR pump, or colloquially "smog pump" turned by the engine via a belt or electric motor.The pump's air intake is filtered by a rotating screen or the vehicle air filter to exclude dirt particles large enough to damage the system.