Search results
Results From The WOW.Com Content Network
Figure 1. An UHTC strake composed of three different sections with different UHTC compositions. [4]Beginning in the early 1960s, demand for high-temperature materials by the nascent aerospace industry prompted the United States Air Force Materials Laboratory to begin funding the development of a new class of materials that could withstand the environment of proposed hypersonic vehicles such as ...
ASA has lower glass transition temperature than ABS, 100 °C vs 105 °C, providing better low-temperature properties to the material. [3] ASA has high outdoor weatherability; it retains gloss, color, and mechanical properties in outdoor exposure. It has good chemical and heat resistance, high gloss, good antistatic properties, and is tough and ...
Therefore the use of organic materials in contact with oxygen should be avoided or minimised, particularly when the material is directly exposed to gas flow. When an organic material must be used for parts such as diaphragms, seals, packing or valve seats, the material with the highest ignition temperature for the required mechanical properties ...
Polystyrene homo-polymers deform when a force is applied until they break. Styrene-butane co-polymers do not break at this point, but begin to flow, solidify to tensile strength and only break at much higher elongation. [63]: 426 With a high proportion of polybutadiene, the effect of the two phases is reversed.
For example, molding at a high temperature improves the gloss and heat resistance of the product whereas the highest impact resistance and strength are obtained by molding at low temperature. Fibers (usually glass fibers) and additives can be mixed in the resin pellets to make the final product strong and raise the maximum operating temperature ...
Cars, and buses have a large use of automotive textiles. A car can consume up to 25 kg of fabric, primarily used for roof coverings and upholstery.Automotive textiles also used in interior trimmings, seats, side panels, carpets, and car trunk coverings, linings, tires, filters, belts, hoses, airbags, etc. [4]
Refractory materials are classified into three types based on fusion temperature (melting point). Normal refractories have a fusion temperature of 1580–1780 °C (e.g. fire clay) High refractories have a fusion temperature of 1780–2000 °C (e.g. chromite) Super refractories have a fusion temperature of > 2000 °C (e.g. zirconia)
It was designed to have high corrosion resistance and strength over a wide temperature range. ETFE is a polymer and its source-based name is poly (ethene-co-tetrafluoroethene). It is also known under the DuPont brand name Tefzel and is sometimes referred to as 'Teflon Film'. ETFE has a relatively high melting temperature and excellent chemical ...