Ads
related to: milwaukee vinyl siding stapler accessories set of 4 3 6
Search results
Results From The WOW.Com Content Network
A Hammer stapler is a tool used for securing a variety of thin plastic and paper sheet building materials against flat surfaces by tacking a staple using a high velocity slapping motion similar to that of swinging a hammer. Typically the shallower the staple, the better hold its grip on the surface is.
Thicker grades of vinyl siding may, according to some, exhibit more resistance to the most common complaint about vinyl siding – its tendency to crack in very cold weather when it is struck or bumped by a hard object while others feel that a thinner product may allow more 'flex before cracking' and is a subject of debate. However, at "This ...
By 1935, Milwaukee Electric Tool Corporation developed a lightweight 3/4" electric hammer drill. This power tool was designed to drill and sink anchors into concrete. This drill could also be converted into a standard 3/4" drill. Milwaukee also designed an easy-to-handle, single-horsepower sander/grinder that weighed only 15 pounds. [7]
This type of stapler is typically used for insulation, roofing and carpeting. For most purposes square end staples are used; but some staplers can take rounded end staples for holding cables against a surface. Typical staple leg lengths are 1 ⁄ 4 ″, 5 ⁄ 16 ″, 3 ⁄ 8 ″, 1 ⁄ 2 ″, 17 ⁄ 32 ″, and 9 ⁄ 16 ″, or 6, 8, 10, 12 ...
Eight years later the company changed its name to Speed Products and created the first top-opening stapler, allowing easy refilling of a full strip of staples. [3] The design of this stapler, called the "Swingline" in 1935, [4] eventually became the industry standard. In 1956 the company was renamed Swingline, and in 1968 introduced the ...
A heavy duty office staple might be designated as F1667 STFCC-04: ST indicates staple, FC indicates flat top crown, C indicates cohered (joined into a strip), and 04 is the dash number for a staple with a length of 0.250 inch (6 mm), a leg thickness of 0.020 inch (500 μm), a leg width of 0.030 inch (800 μm), and a crown width of 0.500 inch ...