When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   An annular cutter (also called a core drill, core cutter, broach cutter, trepanning drill, hole saw, or cup-type cutter) is a form of core drill used to create holes in metal. An annular cutter, named after the annulus shape , cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center.

3. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   Annular cutters in tungsten carbide tip (TCT) and high-speed steel (HSS) The magnetic core drilling machine utilizes core drills or annular cutters . With a cutter wall thickness of approximately 5 mm only a small amount of material around the edge of a hole is removed by an annular cutter. [ 4 ]

4. Core drill - Wikipedia

   en.wikipedia.org/wiki/Core_drill

   Core drills used in metal are called annular cutters. Core drills used for concrete and hard rock generally use industrial diamond grit as the abrasive material and may be electrical, pneumatic or hydraulic powered. Core drills are commonly water cooled, and the water also carries away the fine waste as a slurry. [1]

5. Milling cutter - Wikipedia

   en.wikipedia.org/wiki/Milling_cutter

   Milling cutters may have from one to many teeth, with two, three and four being most common. Typically, the more teeth a cutter has, the more rapidly it can remove material. So, a 4-tooth cutter can remove material at twice the rate of a two-tooth cutter. Helix angle: The flutes of a milling cutter are almost always helical. If the flutes were ...

6. Hole saw - Wikipedia

   en.wikipedia.org/wiki/Hole_saw

   Tungsten carbide hole saw with arbor A 52 mm (2.0 in) hole saw with pilot bit A 115 mm (4.5 in) diamond hole saw. A hole saw (also styled holesaw), also known as a hole cutter, [1] is a saw blade of annular (ring) shape, whose annular kerf creates a hole in the workpiece without having to cut up the core material.

7. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.