Ad
related to: inboard vs outboard direction sensor replacement battery chart
Search results
Results From The WOW.Com Content Network
A sterndrive or inboard/outboard drive (I/O) is a form of marine propulsion which combines inboard power with outboard drive. The engine sits just forward of the transom while the drive unit ( outdrive or drive leg ) lies outside the hull .
Inboard: attached inside the ship. [15] Keel: the bottom structure of a ship's hull. [16] Leeward: side or direction away from the wind (opposite of "windward"). [17] On deck: to an outside or muster deck (as "all hands on deck"). [18] On board: on, onto, or within the ship [19] Onboard: somewhere on or in the ship. [20] Outboard: attached ...
A Battery: Eveready 742: 1.5 V: Metal tabs H: 101.6 L: 63.5 W: 63.5 Used to provide power to the filament of a vacuum tube. B Battery: Eveready 762-S: 45 V: Threaded posts H: 146 L: 104.8 W: 63.5 Used to supply plate voltage in vintage vacuum tube equipment. Origin of the term B+ for plate voltage power supplies.
The pivoting design allows the outboard motor to be swiveled by the operator in almost all directions: Sideways for direction, up and down to change the thrust line according to speed or bow lift, elevate completely out of water for easy starting, placing the drive shaft and the propeller forward along the side of the boat for reverse, or put ...
Previously, as with other outboard brands and Mercury's smaller models, exhaust exited from a chute at the rear of the cavitation plate above the propeller. Thru-hub exhaust was claimed to be more efficient by omitting the added drag of an exhaust chute, and using the low-pressure area necessarily created by the gear housing and propeller ...
Low self-discharge nickel–metal hydride battery: 500–1,500 [14] Lithium cobalt oxide: 90 500–1,000 Lithium–titanate: 85–90 6,000–30,000 to 90% capacity
A 260-horsepower (190 kW) diesel inboard motor An inboard motor is a marine propulsion system for boats.As opposed to an outboard motor, where an engine is mounted outside the hull of the craft, an inboard motor is an engine enclosed within the hull of the boat, usually connected to a propulsion screw by a driveshaft.
It is a four-stroke, vertical, water-cooled diesel engine. It is built around two cylinders (hence the "2" in 2GM20) of 75 mm in diameter and 72 mm in stroke, adding up to 0.635 litres in displacement: each cylinder is roughly the size and volume of a 300 ml soft-drink can.