Search results
Results From The WOW.Com Content Network
Three individual Rochester 2G carburetors were arranged inline on the intake manifold, the center one operating normally and the outer two acting as secondaries, or "dumpers", for full throttle performance. Tri-Power often included a hood bulge to accommodate the carburetor set-up and identifying badging on the vehicle's exterior.
Air from the atmosphere enters the carburetor (usually via an air cleaner), has fuel added within the carburetor, passes into the inlet manifold, then through the inlet valve(s), and finally into the combustion chamber. Most engines use a single carburetor shared between all of the cylinders, though some high-performance engines historically ...
A teen on a minibike in Thailand. While the minibike had precursors in machines such as the Doodle Bug and Cushman Scooters, which share smaller wheels, tubular-steel frames, and air-cooled, single-cylinder engines, those vehicles had larger seat heights and lighting that allow them to be registered for road use as scooters.
The Motorcraft 2150 is a Ford (also used by AMC) 2-barrel carburetor manufactured from 1973 through 1983, [1] based heavily on its predecessor, the Autolite 2100 carburetor. The 2150 improved on the 2100s design through the introduction of a variable air bleed system, which keeps the air to fuel mixture better balanced throughout the carburetor ...
The Autolite 2100 is a two venturi (barrel) carburetor manufactured in multiple variants by Autolite from 1957 to 1973. Eight sizes ranging from 190 cfm to 424 cfm were made, all with synchronized venturis, variously with manual, electric, or automatic hot-air chokes.
L – Rupp manufactured two L-series dirt bikes in 1973, the L80 and L100. Both bikes used 2-cycle Fuji engines, in 80 and 100cc sizes. They were equipped with four- and five-speed manual transmissions, respectively. SS – The SS-5 was Rupp's only dirt bike that used a Tecumseh engine and automatic transmission. The engine was a Tecumseh HS50 ...
rattleCAD is a parametric 2D computer-aided design (CAD) software specific for bicycle design, [1] [2] in particular for design bicycle frame, [3] [4] developed by the Austrian cyclist and programmer Manfred Rosenberger since 2008. [5]
Autolite 4300A Carburetor. The Autolite 4300 was a four-barrel (four venturi) carburetor manufactured by Autolite in multiple variants from 1967 through 1974. Used by both Ford and AMC, it was produced as an emissions-compliant replacement for the previous Autolite 4100 model, and was superseded by the Motorcraft 4350.