Search results
Results From The WOW.Com Content Network
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
The R also incorporated live hydraulics. PowrTrol, as it was known, provided the operator the ability to lift equipment by the pull of a lever. A pump powered by the PTO clutch provided 1,800 psi (12 MPa) of hydraulic pressure to a lever controlled valve. At 45 hp (34 kW) at the drawbar and 50 hp (37 kW) at the belt, it was the most fuel ...
Power steering is a system for reducing a driver's effort to turn a steering wheel of a motor vehicle, by using a power source to assist steering. [1]Hydraulic or electric actuators add controlled energy to the steering mechanism, so the driver can provide less effort to turn the steered wheels when driving at typical speeds, and considerably reduce the physical effort necessary to turn the ...
When the pump is configured for low displacement, it produces a low volume of oil flow, causing the hydraulic motor(s) to turn more slowly. As the pump's displacement is increased, a greater volume of oil flow is produced for any given engine RPM, causing the motor(s) to turn faster. Advantages of a hydrostatic CVT include: Capacity scalability.
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
If an NPSH A is say 10 bar then the pump you are using will deliver exactly 10 bar more over the entire operational curve of a pump than its listed operational curve. Example: A pump with a max. pressure head of 8 bar (80 metres) will actually run at 18 bar if the NPSH A is 10 bar. i.e.: 8 bar (pump curve) plus 10 bar NPSH A = 18 bar.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A hydraulic pump is a mechanical source of power that converts mechanical power into hydraulic energy (hydrostatic energy i.e. flow, pressure). Hydraulic pumps are used in hydraulic drive systems and can be hydrostatic or hydrodynamic. They generate flow with enough power to overcome pressure induced by a load at the pump outlet.