When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Watts Brothers Tool Works - Wikipedia

   en.wikipedia.org/wiki/Watts_Brothers_Tool_Works

   They are known for manufacturing drill bits that can drill square holes, [1] [2] including blind holes, which cannot be made with other methods such as broaching. The Harry Watts square drill bit is based on a Reuleaux triangle shape. It is used together with a guide and a particular chuck to make a square hole.

3. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The brad point drill bit (also known as lip and spur drill bit, and dowel drill bit) is a variation of the twist drill bit which is optimized for drilling in wood. Conventional twist drill bits tend to wander when presented to a flat workpiece. For metalwork, this is countered by drilling a pilot hole with a spotting drill bit.

4. Tripping (pipe) - Wikipedia

   en.wikipedia.org/wiki/Tripping_(pipe)

   Vertical Drill Bit. Drill bits wear and tear like most any other piece of equipment. Once a bit becomes too worn to drill at an adequate rate or make a full-gauge hole, or if the bearings are thought to be near failure, a trip is undertaken to replace the bit. A trip is not considered a bit trip when the purpose of replacing the bit is to ...

5. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.

6. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   The drill bit is not held solidly in the chuck, but can slide back and forth like a piston; it does not slip during rotation due to the non-circular shank cross-section, matching the chuck. The hammer of the drill acts to accelerate only the drill bit itself, and not the large mass of the chuck, which makes hammer drilling with an SDS shank ...

7. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   A brace is a hand tool used with a bit (drill bit or auger) to drill holes, usually in wood. Pressure is applied to the top while the handle is rotated. If the bit's lead and cutting spurs are both in good working order, the user should not have to apply any pressure other than for balance: the lead will pull the bit through the wood.