Search results
Results From The WOW.Com Content Network
A tie in building construction is an element in tension rather than compression and most collar beams are designed to work in compression to keep the rafters from sagging. [2] [3] A collar near the bottom of the rafters may replace a tie beam and be designed to keep the rafters from spreading, thus are in tension: these are correctly called a ...
The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs. In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam. There are two main types of timber roof trusses: closed, in which the bottom chord is ...
A hat made from the fur of the Karakul breed of sheep, typically worn by men in Central and South Asia. Keffiyah or Ghutrah: Three piece ensemble consisting of a Thagiyah skull cap, Gutrah scarf, and Ogal black band. Kepi: A generic worldwide military hat with a flat, circular top and visor. First seen in central Europe. Kippah or Yarmulke
c. 1910 top hat by Alfred Bertiel European royalty, 1859 Austin Lane Crothers, 46th Governor of Maryland (1908–1912), wearing a top hat. A top hat (also called a high hat, or, informally, a topper) is a tall, flat-crowned hat traditionally associated with formal wear in Western dress codes, meaning white tie, morning dress, or frock coat.
By supporting the rafters they allow longer spans than the rafters alone could span, thus allowing a wider building. Purlin plates are very commonly found in large old barns in North America. A crown plate has similarities to a purlin plate but supports collar beams in the middle of a timber-framed building.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Crown post roof in the solar at Old Soar Manor in 2009: the crown post is the upright above the tie beam. It carries a beam called the crown plate which in turn supports the collar beams. There are braces between the collar beams and common rafters and from the crown posts to these braces.
The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple. Depending on the roof covering material, either horizontal laths , battens , or purlins are fixed to the rafters; or boards, plywood , or oriented strand board form the roof deck (also called the sheeting or ...